The large kit contains the capsules to install -10, -12, -16 hose into their respective sockets. To accommodate all the different manufacturer’s fittings, spacers and sleeves are required to tighten up some of the sockets within the capsule. For the tool to perform at its best, the socket needs to be a snug fit into the funnel. In the 1016  kit, all the -16’s except Russell’s require the sleeve and a rear spacer. See the instructions in the case for the proper spacer number. Most of the -10’s and 12’s* will use a spacer. Not for use with Teflon-style hose.

* -12 is a stainless washer.

The Hot Rod kit contains the capsules to install -6, -8, -10 hose into their respective sockets. To accommodate all the different manufacturer’s fittings, spacers and sleeves are required to tighten up some of the sockets within the capsule. For the tool to perform at its best, the socket needs to be a snug fit into the funnel. Spacers are used in some -6‘s, -8‘s, and most -10's. If the socket seems loose in the tool, use a spacer to tighten it up. See the instructions in the case for the proper spacer number. Not for use with Teflon-style hose.

The Pro Combo is a special offer of BOTH the #468 and #1016 kits listed above. Pros need both kits to handle all the hose sizes in a race car. Ordering this combination will save $15.00. Not for use with Teflon-style hose.